管头支架

Spellman LPX 系列非常适合当今严苛的 NDT 检测要求。LPX 装置坚固耐用，便于运输，LPX1620 管头支架（选配）有助于快速安装，它提供刚性支撑，以便于获取最佳图像质量。管头支架整合了伸缩腿、手轮驱动的可变高度调节装置以及用于控制管头倾斜和水平旋转的可锁式手轮。管头护架有缓冲垫，可确保稳固安装和减振。其中所含的气泡型指示器有助于快速方便地校平管头。

LPX1620  管头支架与所有 LPX160、LPX200 和 LPX300 管头组件兼容

规格

^{(128098-001 REV. B)}

Horizontal Rotation:

 360°

 Tilt:

 -45° to +90°

Dimensions:

Footprint of legs: 43˝ (109cm) min., 70.5˝ (179cm) max.

Floor to center line of tubehead ring: 45.5˝ (115cm) min., 83.5˝ (212cm) max.

Weight:

35lbs. (16kg)

SET-UP

1. Extend tripod legs outward
2. Loosen height lock knob and raise gearhead mount approx. 3 inches
3. Place gearhead on tripod shaft. Align set screw hole in shaft with hole in gearhead mount. Using supplied hex key, tighten set screw to engage gear head mount.
4. Mount tubehead in cradle. Open knurled latch and outer ring to remove cradle assembly. Release the two hook latches on the cradle to open it. Fit cradle over tubehead making sure any cooling manifolds are positioned between cushioning pads. Latch the hook latches securely.
5. Mount cradle in the gear head outer ring. Close and latch the knurled knob locking mechanism.
6. Use the height, tilt, and rotation controls to position the X-Ray tubehead as needed. Lock all adjustments before making X-Ray exposures.

LPX1620 MODEL SELECTION TABLE

表和图

DIMENSIONS: in. [cm]